Panasonic SC-NT10 - Using Boost Mode; Using the AUX Input; Auto Power off

11
VQT5A86
It will make the sound played back on this unit easier to hear by boosting the
level of specific frequency band.
Press
[BOOST] of this unit to switch the effect on/off.
• The Boost Mode indicator (orange) lights up.
Note
• If sound is distorted during playback, switch off the “Boost Mode”.
• When saving the power consumption, set “Boost Mode” to “off”.
• Location of this unit may move due to vibration.
You can listen to the audio via AUX IN jack (> 5) when this unit is connected
to the device with the audio cable (not supplied).
Note
• When using the AUX input, the Bluetooth
®
audio, NFC features, and [ ] are not available.
(It will be possible to receive a call hands-free by pressing [ ] when there is a call coming in on
the device connected with Bluetooth
®
. > 12)
• The setting of the Bluetooth
®
is not changed even if inserting the audio cable (not supplied) from
AUX IN jack.
• When using the AUX input, the volume may seem low depending on the connected device. In that
case, check if the volume limit can be changed on the device. For details, refer to the manual of the
device.
This unit automatically turns off if there is no audio input and no operation is
performed for approximately 10 minutes.
Note
• This function will not operate when the AUX input is used while connected with the USB cable.
• This function may operate even when the music is being played back if the volume of the connected
device is low.
• This function may not operate depending on the connected device.
Using Boost Mode
Using the AUX input
Auto Power Off
SC-NT10_VQT5A86_eng.book 11 ページ ２０１３年６月６日 木曜日 午後１２時２２分