Panasonic SC-NT10 - Listening to Audio from a Bluetooth Device; Connecting Via Bluetooth Menu

VQT5A86
8
Preparation
While charging this unit or after charging this unit, turn on the Bluetooth
®
feature of the device and place the device near this unit.
If you intend to use an NFC (Near Field Communication)-compatible
Bluetooth
®
device, proceed to “ One-Touch Connection (Connecting by
NFC)” (> 9).
For each Bluetooth
®
device you want to connect to via Bluetooth
®
, perform
pairing first.
∫ Pairing with
Bluetooth
®
device
1 Press [Í/I] to turn this unit on.
• The Bluetooth
®
indicator (blue) blinks slowly.
• If this unit is being used for the first time (factory preset state):
The Bluetooth
®
indicator (blue) blinks fast. → The unit will enter pairing standby.
→ Skip to step 3.
2 Press and hold [ ] until the Bluetooth
®
indicator (blue) blinks
fast.
• The unit will enter pairing standby.
3 Select “SC-NT10” from the Bluetooth
®
device’s Bluetooth
®
menu.
• When the Bluetooth
®
device is paired and connected, the Bluetooth
®
indicator (blue) on the
unit lights up.
• If prompted for a passkey, input “0000”.
• If the Bluetooth
®
device need to operate the Bluetooth
®
pairing setting and the Bluetooth
®
connecting setting, operate both settings.
4 Start playing back music, a movie, etc. on your Bluetooth
®
device.
• Adjust the volume using the [VOL -/VOL +] buttons on the unit.
When the maximum or minimum volume is reached, you will be notified by a beep sound.
∫ Listening to audio from a paired device
When this unit is turned on, the Bluetooth
®
indicator (blue) will blink slowly
indicating that the unit is in connection standby mode. Please perform Steps
3 and 4.
• When the power is turned on, this unit is connected to the last-used Bluetooth
®
device. At this point,
please perform Step 4.
Listening to audio from a Bluetooth
®
device
Connecting via Bluetooth
®
menu
SC-NT10_VQT5A86_eng.book 8 ページ ２０１３年６月６日 木曜日 午後１２時２２分