Panasonic SC-PM07

Listening
operations
O o aQ*
Ho 6 6 Si
V/REW/H-*, A/FF/»I
CD PLAY
MODE
1 STOP ■
CLEAR ; L d lb HO-i-rc?
3 1 2 3
o o o
4 5 6 S10
o o o o
7 8 9 0
Q O O O
■ Specified track
number
i i i~i .... ) i i
i Ld id ~ u i:
■ tiaraa
Program order
Ml
% \Cd fl : .'.0015
C d
in i
i—11— i—
Program play
by remote control only
This function allows you to program up to 36 tracks.
1 Press [STOP ■ ] to select the CD mode.
2 (In the stop mode)
Press [PGM/-CLEAR].
3 Press the numeric button(s) to select the
track you want to play in the desired
sequence.
4 Repeat step 3 until you have programmed all
the tracks you want.
5 Press [CD ► 711].
Play will start in the programmed sequence.
Play will stop automatically when all the programmed
tracks have been played.
The program remains intact even if play is stopped or
the unit is turned off. “Cd-P” appears when play is
stopped to indicate the contents are in the memory.
To cancel program play mode
Press and hold [PGM/-CLEAR] in the stop mode until
“CLEAR” is displayed.
The mode is also canceled if the CD tray is opened.
This will also erase the entire program.
To select a two-digit track
Press [510] and then the two numbers you want.
Q When is displayed
Total play time of the programmed tracks equals, or
exceeds 100 minutes.
Tracks can still be programmed and played.
B When “FULL” appears
The number of programmed tracks is limited to 36. No
further tracks can be programmed.
Q Check program contents
Check to see if “Cd-P” is displayed, then press either [V/
REW/F4*] or [A/FF/^W].
Everytime you press one of the buttons, the track and
program No. are shown on the display.
Add to the program.
In the stop mode, repeat step 3.
Program play does not work when “RANDOM” is displayed
(press [CD PLAY MODE] to clear it) (^ page 13).
Search can be done within tracks only.
Memory retention
Your program is retained in memory for about 2 weeks
while the system is unplugged.
Indicates program mode
d-P H9 73 ;
RQT6096