Panasonic SC-PM11

Indicates program mode --s_
-7
You can program up to 24 tracks.
Press [SELECTOR] to select “CD”.
Every time you press the button:
CD+TAPE-tTUNER+AUX
LL
R
Press [PROGRAM].
El
Press [DISC].
0
, (within 10 seconds or so)
Press [l] - [5] to select the disc you want.
2
H
Press the numeric button to select the desired track.
‘g
f
0
’
Repeat steps q through q until you have pro-
grammed all the tracks you want.
3
Y
Press [CD b/II].
Play will start in the programmed sequence
To cancel program play mode
Press [PROGRAM] in the stop mode.
8
Programmed contents will be saved in memory.
Pressing [W CLEAR] will cancel program play, but it will also erase the
entire program.
To select a two-digit track
Press [>I01 and then the two numbers you want.
q When “CD FULL” appears
The number of programmed tracks is limited to 24. No further tracks
can be programmed.
q You can do the following during program mode
0 Check program contents.
Press [hlH] or [HI].
Every time you press one of the buttons, the track and program No.
are shown on the display.
l Add to the program.
Repeat steps H through 8.
l Cancel entries.
press [CANCEL] within 3 seconds.
Memory retention
Your program is retained in memory for about 2 weeks while the
system is unplugged.
To replay your program
If you turned OFF your program with [PROGRAM], you can play it
again as explained below.
1. Press [PROGRAM].
2. Press [CD )/II].
If you program a track not on your CDs
The track is initially programmed, but during program play, the player
will skip that track and will continue playing from the next programmed
item.