Panasonic SC-PM11

00
Tab for side “B”
Normal tape
Tab for side “A” -
To re-record
Hi-position tape
00
Discrimination hole
-0
To fast-forward or rewind the tape
Press [HIIREWIV] or [AIFWbbi] in the stop mode.
Tape direction
To rewind
To fast-forward
‘6 @ ‘I
[l+4/REW/V] [AIFFIW]
“ 4 ”
[l++/REW/V]
[AIFFIH]
To find the beginning of a program
(TPS: Tape Program Sensor)
TPS finds the beginning of a track and resumes play from there. Each
press increases the number of tracks skipped, up to a maximum of 9.
Press [HI/REW/V] or [h/FF/b+l] during play.
The TPS function searches for silent parts of about 4 seconds in
length which are normally found between tunes. As a result, it may not
function properly in the following cases:
l With short silent parts
l When noise occurs between tunes
l With silent parts found within tunes
.
Selection of tapes for recording
The unit automatically identifies the type of tape.
Normal position/TYPE I (/
Hiah oosition/TYPE II d
I
r%letal position/TYPE IV )
X
I
Metal position tapes can be used, but the unit will not be able to
record or erase them correctly.
Erasure prevention
The illustration shows how to remove the tabs to prevent recording.
To record on the tape again, cover as shown, being careful not to
cover the high position discrimination hole.
1 How volume, sound quality/ field affect recording 1
l Recording level is set automatically.
l All sound effects are automatically set to flat.
Erasing recordings
@ Press [SELECTOR] to select ‘TAPE”.
Every time you press the button:
CD + TAPE + TUNER --f AUX
4 I
@ Insert the recorded tape into deck.
@ Press [REV MODE] to select the reverse mode
@ Press [O REC/II].