RQT9988
10
Press [DISPLAY].
• For Continental Europe:
Press [DISPLAY] repeatedly to select “FM STATUS”.
(For Continental Europe only)
This system can show the text data transmitted by the
radio data system (RDS) available in some areas.
Press [DISPLAY] repeatedly.
Note:
• RDS is available only when stereo works in reception.
• RDS may not be available if reception is poor.
[PMX70B] DAB+
Preparation
Press [RADIO, EXT-IN] repeatedly to select “DAB+”.
If you select “DAB+” for the first time, the system will
start the “DAB AUTO SCAN” procedure.
Note:
• If no station is detected, “SCAN FAILED” is shown.
Adjust the antenna and try again.
1 Press [RADIO MENU] to select “AUTOSCAN” and
then press [OK].
“START?” is shown.
2 Press [OK].
“DAB AUTO SCAN” is shown.
To find the best antenna position, use manual tuning to
search selected DAB frequency block.
1 Press [RADIO MENU] repeatedly to select
“MANUAL SCAN”.
2 Press [2, 1] to select a frequency block to scan
and then press [OK].
You can preset up to 20 DAB stations.
1 Press [6] or [5] to select a station.
• Alternatively, press [:/6] or [5/9] on the
main unit when “STATION” is selected as the tune
mode*
1
.
2 Press [PROGRAM].
3 Press the numeric buttons to select a preset
number.
Do steps 1 through 3 again to preset more stations.
Note:
• A station previously stored is overwritten when another
station is stored in the same preset number.
• You cannot preset a station when the station is not
broadcasting or when you have selected a secondary
service.
• Previous station memory is cleared during auto scan.
Press the numeric buttons, [:] or [9] to select
the preset station.
• Alternatively, press [:/6] or [5/9] on the main
unit when “PRESET” is selected as the tune mode*
1
.
*1: To change the tune mode
1 Press [RADIO MENU] repeatedly to select “TUNE
MODE”.
2 Press [2, 1] to select “STATION” or “PRESET”, and
then press [OK].
You can view information about the DAB broadcast,
programme type, ensemble label, frequency and time.
Press [DISPLAY] to view available information.
1 Press [RADIO MENU] repeatedly to select an
option.
2 Press [2, 1] to select the desired setting and
then press [OK].
When adjusting the antenna, you can check the
reception quality.
1 Press [RADIO MENU] repeatedly to select
“SIGNAL QUALITY”.
2 Press [2, 1] to select frequency.
The current frequency block is displayed and then
the reception quality is indicated.
To display the current FM signal status
“FM ST”: The FM signal is tuned and in stereo.
“FM - - - -”: There is no tuned signal or the FM signal
is in monaural.
“FM MONO”: “MONO” is selected as the “FM MODE”.
(> 12, “If noise is excessive during FM
reception.”)
RDS broadcasting
“PS”: Programme service
“PTY”: Programme type
“FREQ”: Frequency
DAB auto scan
DAB manual tuning
Memory presetting
Selecting a preset station
Viewing available information
DAB settings
DAB SECONDARY
PRIMARY To listen to primary service.
SECONDARY To listen to secondary services.
“ ” is shown.
AUTO CLOCK ADJ
ON ADJUST Start auto clock adjustment.
OFF ADJUST Cancel auto clock adjustment.
DAB signal quality
Reception quality
0 (poor) to 8 (excellent)
SC-PMX70-70B_EGEBGN-RQT9988-B.book 10 ページ ２０１４年１２月２９日 月曜日 午後１時２１分
To Next Page
Loading...
