Panasonic SC-PT464

11
RQTX0217
Getting StartedPlaying DiscsOther OperationsReference
Up to 30 stations can be set.
A station previously stored is overwritten when another station is stored in
the same channel preset.
The step is factory-set to 0.2-MHz, but you can change it to receive
broadcasts allocated in 0.1-MHz steps. You may need to change this
setting if the tuner seems to skip over the correct frequency for stations in
your area.
Press and hold [FUNCTIONS].
After a few seconds, the display changes to show the current minimum
frequency. Continue to hold the button down. The minimum frequency
changes and the step is changed.
e.g. 87.9 (Factory preset) ,# 87.5
To return to the original step, repeat the above step.
[Note]
After changing the setting, previously preset frequencies will be cleared.
Preset them again.
Selecting the playback source
You can select desired source or access playback/menus by using the
START menu.
When “Input select” is selected
You can select a desired source from the menu.
≥ DVD/CD (B 9), FM (B 10), AUX
§
(B 12), DIGITAL IN
§
(B 12),
iPod (B 22)
§
“(TV)” will appear beside “AUX” or “DIGITAL IN”, indicating the TV
audio setting for VIERA Link “HDAVI Control” (B 20).
When a disc is loaded, you can also access playback or menus from the
START menu.
e.g. [DVD-V]
When the on-screen control panel appears
e.g. [DVD-V] (when “Playback Disc” is selected from the START menu)
You can operate the playback with the indicated controls.
(Continued on next page)
Presetting stations manually
1 While listening to the radio broadcast
Press [OK].
2 While the frequency is flashing on the display
Press the numbered buttons to select a channel.
≥ To select a 2-digit number
e.g. 12: [S10] B [1] B [2]
Alternatively, press [X, W], and then press [OK].
Main unit:
1 While listening to the radio broadcast
Press [MEMORY] twice.
2 While a channel number is flashing on the display
Press [X TUNE W], and then press [MEMORY].
FM frequency step
Selecting the source from the START menu
1
Show the START
menu.
This unit automatically turns on.
(The TV also turns on when using
VIERA Link “HDAVI Control”. This
works only when in “DVD/CD” or
“IPOD” mode without any disc/
device being loaded/connected.)
e.g.
2
Select an item.
≥ To exit, press [START].
OK
S
T
A
R
T
OK
START
S
T
A
R
T
DVD/CD Home theater
OK
RETURN
Input select
OK
DVD/CD Home theater
OK
RETURN
Input select
Playback Disc
TOP MENU (DVD)
MENU (DVD)
Playback/menu access
SC-PT464_462P-RQTX0217-P_eng.book Page 11 Friday, February 13, 2009 1:53 PM