Panasonic SC-SB1

Operations
11
TQBS0131
Bluetooth
®
connection
By using the Bluetooth
®
connection, you can listen
to the sound from the Bluetooth
®
audio device
from this system wirelessly.
≥ Refer to the operating instructions of the Bluetooth
®
device
for further instruction on how to connect a Bluetooth
®
device.
Preparation
≥ Turn on the Bluetooth
®
feature of the device and
place the device near this system.
1 Press [ ] to select “ ”.
≥ If the “ ” indicator flashes quickly, go to step 3.
2 Press and hold [ ] until the “ ” indicator
flashes quickly.
≥ If the “ ” indicator flashes slowly, repeat step 2.
3 Select “SC-SB1” from the Bluetooth
®
device’s Bluetooth
®
menu.
≥ If prompted for the passkey on the Bluetooth
®
device,
enter “0000”.
≥ Once the Bluetooth
®
device is connected, the “ ”
indicator stops flashing and lights up.

≥ You can register up to 8 devices with this system. If a 9th
device is paired, the device that has not been used for the
longest time will be replaced.
1 Press [ ] to select “ ”.
≥ If the “ ” indicator lights, a Bluetooth
®
device is
already connected with this system. Disconnect it.
(> below)
2 Select “SC-SB1” from the Bluetooth
®
device’s Bluetooth
®
menu.
∫ Disconnecting a Bluetooth
®
device
Press and hold [ ] until the “ ” indicator flashes.

≥ This system can only be connected to one device at a time.
Advanced operations
This system is automatically turned off if there is no audio
input and when you do not use it for approx. 19 min and
30 sec.
1 While pressing
and holding
[i SUBWOOFER]
on the remote control, press and hold
[VOL s] on this system for more than
4 sec.
≥ The current mode will be indicated by the
corresponding LED indicator.
2 While the current mode is indicated (about
20 sec), press [i SUBWOOFER] again.
≥ The setting changes each time [i SUBWOOFER] is
pressed.
≥ The indicator for the selected setting blinks for 20 sec and
then exits the setting mode.
≥ The setting is maintained until it is changed again.
≥ Default setting of this function is “On”.
This function allows you to connect a paired Bluetooth
®
device when this system is in standby mode.
1 While pressing
and holding
[SUBWOOFER j]
on the remote control, press and hold
[VOL s] on this system for more than
4 sec.
≥ The current mode will be indicated by the
corresponding LED indicator.
2 While the current mode is indicated (about
20 sec), press [SUBWOOFER j] again.
≥ The setting changes each time [SUB WOOFER j] is
pressed.
≥ The indicator for the selected setting blinks for 20 sec and
then exits the setting mode.
≥ The setting is maintained until it is changed again.
≥ Default setting of this function is “On”.
Bluetooth
®
pairing
Connecting a paired
Bluetooth
®
device
Auto Power Down
Bluetooth
®
Standby
“On” “Off”
“On” “Off”
SC-SB1_EB_TQBS0131.book 11 ページ ２０１７年４月１０日 月曜日 午後１時２２分