Panasonic SC-SB1

6
TQBS0131
1 Turn this system on or off (> 9)
2 Select the input source (> 9)
“HDMI(BD)” --# “HDMI(TV)” --# “AUX”
^----------- “ ” (Bluetooth
®
) -----------}
3 Select the Bluetooth
®
device as the source
(> 9)
4 Select the sound mode (> 9)
5 Adjust the bass (adjustable in four steps)
6 Switch the brightness of the LED indicators
7 Adjust the volume of this system (> 9)
8 Mute the sound (> 9)
9 Adjust the delay between video and audio
1 Press [AUDIO DELAY] on the remote control.
≥ The current mode will be indicated by the
corresponding LED indicator.
2 While the current mode is indicated (about
10 sec), press [i SUBWOOFER] or
[SUBWOOFER j].
≥ The setting changes in the following order each
time you press [i SUBWOOFER].
(It changes in the reverse order if you press
[SUBWOOFER j].)
“Auto” --# “Off” --# “Level 1” --# “Level 2”
≥ If no operation is performed for about 10 sec or any
button other than [i SUBWOOFER],
[SUBWOOFER j] or [DIMMER] is pressed, the
indicators return to normal status.
(If the bass is accidentally adjusted when
[i SUBWOOFER] or [SUBWOOFER j] is
pressed, follow the steps again from step 1.)
≥ The symbols on the supplied remote control
represent the following:
Remote control
ュリヮヮユン
ヴヶャヸヰヰョユン
ヮヶヴリヤ ヷヰリヤユ
ヴヵモワュモンュ ヤリワユヮモ
5
7
6
9
8
1
2
3
4
Lowest
Highest
∫ Before using for the first time
Remove the insulation sheet A.
∫ To replace a button-type battery
Battery type: CR2025 (Lithium battery)
≥ Set the button-type battery with its (i) mark
facing upward.
Warning (refer to Operating Instructions for the button
cell battery)
"Level 1"
"Level 2"
“Auto”
"Off”


SC-SB1_EB_TQBS0131.book 6 ページ ２０１７年４月１０日 月曜日 午後１時２２分