Panasonic SC-UA90

17
TQBJ2140
D:\Publishing\Panasonic\SC-UA90.70\SC-UA90 GS.GW TQBJ2140 En.fm
External equipment
Preparation
• Disconnect the AC mains lead.
• Switch off all equipment and read the appropriate
operating instructions.
Note:
• Do not bend cables at sharp angles.
• Components and cables are sold separately.
• Sound distortion can occur when you use an adaptor.
• If you want to connect equipment other than those
described, refer to the audio dealer.
Using the optical input
You can connect a TV, VCR, DVD player etc., and listen to
the audio through this system.
1 Connect the external equipment.
2 Press [SELECT <, >] repeatedly to select “D-IN”.
3 Play the external equipment.
Note:
• This system supports linear PCM and Dolby Digital signals.
• Multi-channel source will be converged to 2 channels.
• Sampling frequency: 32 kHz (PCM), 44.1 kHz (PCM) and
48 kHz
• The sound is muted if the signal format or frequency is not
supported.
• If there are sounds coming from the TV’s speakers,
decrease the volume of the TV to its minimum.
Using the auxiliary input
You can connect a VCR, DVD player etc., and listen to the
audio through this system.
1 Connect the external equipment.
2 Press [SELECT <, >] repeatedly to select “AUX”.
3 Play the external equipment.
█ AUX mode
1 Press [PLAY MENU] to select “AUX MODE”.
2 Press [Y, U] to select the mode and then press
[OK].
Rear panel
of this unit
Optical digital
audio cable
(not supplied)
TV (not supplied)
MODE 1
(default)
Select this mode to use the Karaoke effect
function.
MODE 2 Select this mode when watching TV, movies
or using an external player with Karaoke
features.
Rear panel
of this unit
Audio cable
(not supplied)
DVD player (not supplied)
SC-UA90 GS.GW TQBJ2140 En.fm Page 17 Tuesday, August 7, 2018 9:42 AM