Panasonic SC-UA90

5
TQBJ2140
D:\Publishing\Panasonic\SC-UA90.70\SC-UA90 GS.GW TQBJ2140 En.fm
Preparing the remote control
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with
those in the remote control.
Making the connections
Connect the AC mains lead only after all the other
connections have been made.
1 Connect the FM indoor antenna.
Put the antenna where reception is best.
2 Connect the AC mains lead.
Do not use any other AC mains leads except the
supplied one.
Hold the unit when connecting or disconnecting the
AC mains lead to prevent the unit from falling.
Conserving power
The system consumes a small amount of power even
when it is in standby mode. Disconnect the power
supply if you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
Note:
Keep the antennas away from the AC mains lead to avoid
picking up noise.
Adhesive tape
(not supplied)
To household mains socket
SC-UA90 GS.GW TQBJ2140 En.fm Page 5 Tuesday, August 7, 2018 9:42 AM