EasyManua.ls Logo

Panasonic SC-UX102

Panasonic SC-UX102
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
TQBJ0976
13
External equipment
You can connect a VCR, DVD player etc., and listen to
the audio through this system.
Preparation
Disconnect the AC mains lead.
Switch off all equipment and read the appropriate
operating instructions.
1 Connect the external equipment.
2 Press [RADIO/AUX] to select “AUX”.
3 Play the external equipment.
To adjust the input level
1 Press [PLAY MENU] to select “INPUT LEVEL”.
2 Press [R, T] to select “NORMAL” or “HIGH” and
then press [OK].
Note:
Select “NORMAL” if the sound is distorted during “HIGH”
input level.
Components and cables are sold separately.
If you want to connect equipment other than those
described, refer to the audio dealer.
Sound distortion can occur when you use an adaptor.
Others
Illumination
You can switch on or switch off the illumination on the
system.
1 Press [SETUP] to select “ILLUMINATION”.
2 Press [R, T] to select “ON” and then press [OK].
To cancel, select “OFF”.
Auto off
This system automatically switches off when you do not
use it for approximately 20 minutes.
1 Press [SETUP] to select “AUTO OFF”.
2 Press [R, T] to select “ON” and then press [OK].
To cancel, select “OFF”.
Note:
This function does not work when you are in radio source
or when a Bluetooth
®
device is connected.
SC-UX102
This function does not work when you are in “DAB+”
source.
Bluetooth
®
standby
This function automatically switches on the system when
you establish a Bluetooth
®
connection from a paired
device.
1 Press [SETUP] to select “BLUETOOTH STANDBY”.
2 Press [R, T] to select “ON” and then press [OK].
To cancel, select “OFF”.
Note:
Some devices may take longer to respond. If you are
connected to a Bluetooth
®
device before switching off the
system, wait for a minimum of 5 seconds before connecting
to this system from your Bluetooth
®
device again.
Software version
You can check the software version of the system.
1 Press [SETUP] to select “SW VER.” and then press
[OK].
The software version is shown.
2 Press [OK] again to exit.
Rear panel of
this main unit
Audio cable
(not supplied)
DVD player (not supplied)
ENGLISH
SC-UX102.100 E TQBJ0976 (01) En.fm Page 13 Tuesday, September 13, 2016 10:30 AM

Related product manuals