Panasonic SD39C77JAU6

0.6
0.7
0.8
0.9
1.0
1.1
1.2
-30 -20 -10 0 10
Current (A)
60
80
100
120
140
-30 -20 -10 0 10
Input Power (W)
100
200
300
400
500
600
700
800
-30 -20 -10 0 10
Evaporating Temperature (°F)
Capacity (BTU/H)
110°F 120°F 130°F
Rated Performance Data
Capacity . . . . . . . . . . . . . . 396 Btu/h ±10% *
E.E.R. . . . . . . . . . . . . . . . . . 4.13 Btu/Wh ±10% *
Current . . . . . . . . . . . . . . . 0.90 Amps *
Nominal Motor Data Motor Input . . . . . 96 Watts*
Rated Current . . . 0.90 Amps
Type . . . . . . . . . . RSCR, PTC relay
Locked Rotor . . . . . . . . . . 7.50 Amps
Start Current . . . . . . . . . . 12.99 Amps
Coil Resistances Run . . . . 5.06 Ohms
@ 68°F (20°C) Start . . . 10.78 Ohms
*Test Conditions for Performance Specifications
Test Oil . . . . . . . . . . . . . . . . Freol α 22
Shell Temp . . . . . . . . . . . . . . 170.0°F / 76.0°C
Condensing Temp . . . . . . . . . 130.0°F / 54.4°C
Evaporating Temp . . . . . . . . .-10.0°F / -23.3°C
Ambient Temp . . . . . . . . . . . . 90.0°F / 32.2°C
Gas Superheat . . . . . . . . . . . 90.0°F / 32.2°C
Liquid Sub-Cooling . . . . . . . . 90.0°F / 32.2°C
Electrical Accessories
Overload Protector
Nominal Operating Characteristics
Model Name T135AH3
.
1
Manufacturer Matsushita
Temperature To . . . . . . . . . . . Open: 275°F ± 9°F / 135°C ± 5°C
Close: 176°F ± 27°F / 80°C ± 15°C
Trip Current . . . . . . . . . . . . . . @212°F (100°C) 3.5 to 4.5 Amps
@77°F (25°C) 11.7 Amps @ 13 sec. max.
P.T.C. Starting Device
†
Nominal Operating Characteristics
Model Name PTH490D-AS4R7 PTH7M4R7MD2
Manufacturer Murata Mfg. Murata Mfg.
Base resistance
@ 77°F(25°C) ±20% 4.7 4.7 Ohms
Power Consumption (max) 3.3 3.0 Watts
Operation time 1.3 to 3.0 0.7 to 2.2 seconds
Recovery time (max) 65 70 seconds
Run Capacitor 10 µF 180 V (min.)
†Although these accessories are listed by UL/CSA for use with this compressor,
Matsushita assumes no responsibility whatsoever for these or any other components
sourced by the refrigeration system manufacturer from third parties.
Panasonic Industrial Company
Refrigeration Products Department
Tel: 201 - 392 - 4249
Fax: 201 - 392 - 4315 Rev#1-5/9
Evaporating Temp.
Condensing Temp. Rating -30°F -10°F +10°F
130°F Btu/h 143 396 710
Watts 63 96 126
Amps 0.63 0.90 1.16
E.E.R. 2.27 4.13 5.63
120°F Btu/h 181 417 720
Watts 66 94 120
Amps 0.65 0.89 1.11
E.E.R. 2.74 4.44 6.00
110°F Btu/h 208 430 744
Watts 67 90 115
Amps 0.67 0.86 1.07
E.E.R. 3.10 4.78 6.47
MATSUSHITA Compressor Single Phase 115 V
MODEL# SD39C77JAU6 (10µF Run Cap.) R-134a 60
Hz
Performance Curves
Voltage Range . . . . . . . . . 103 Volts to 127 Volts @ 60 Hz
Application . . . . . . . . . . . . Low Back Pressure
Compressor Cooling . . . . Static Cooling
Refrigerant Control . . Capillary Tube
Evaporator
Temp. Range . . . . . . . -31°F to 23°F / -35°C to -5°C
9 – Point Data
P
a
na
s
o
n
ic
®

Panasonic SD39C77JAU6 Specifications

General

Model	SD39C77JAU6
Category	Air Compressor
Power	2.2kW
Air Delivery	390L/min
Tank Capacity	77L
Max Pressure	8 bar

Summary

Compressor Rated Performance Data

Nominal Motor Data

Details motor input, locked rotor current, start current, and coil resistances.

Performance Specifications and Test Conditions

Electrical Components and Performance Data

Overload Protector

Specifies characteristics, operating temperatures, and trip current for the overload protector.

P.T.C. Starting Device

Details nominal operating characteristics like base resistance and operation time.

Performance Curves and Data Points

Performance Curves

Graphs illustrating input power, current, and capacity versus evaporating temperature.

9 - Point Data

Table presenting performance data (Btu/h, Watts, Amps, E.E.R.) at various temperature points.

Compressor Dimensions and Electrical Diagram

Dimensions

Provides detailed measurements for key components A, B, C, D, and E in mm and inches.

Electrical Diagram

Schematic showing R.S.C.R. internal motor protector, compressor motor, and running capacitor.

Tube Specifications and General Data

Tube Specifications

Details O.D., wall thickness, and material for suction, process, and discharge tubes.

General Data

Includes oil charge, net weight, approved oils, residual moisture, impurities, and displacement.