Panasonic SH-FX71 - Using Surround Back Speakers; Pairing Procedure

Setup
10
10
RQTX1131
Setup
By using 2 sets of SH-FX71, you can enjoy 7.1-channel
playback, making the surround speakers and surround back
speakers wireless (B 7).
≥Keep the digital transmitter of the additional wireless system
for later use.
∫ Pairing
Preparation
≥Make sure to connect the AC mains lead of the additional
wireless system.
≥Turn on the home theater unit and reduce the volume.
[Note]
≥If you should change the digital transmitter card, repeat the
pairing steps using the new digital transmitter.
≥SH-FX71 cannot be used with SH-FX65, SH-FX67 or
SH-FX70.
Using the surround back speakers
Use only a digital transmitter supplied with the SH-FX71.
Wireless system is originally paired to work with the
digital transmitter that comes along with it. For the digital
transmitter to work with the additional wireless system,
pairing is necessary.
Pairing is necessary.
Wireless system
Home theater unit
Additional wireless system
e.g. After pairing
1 Turn on the additional wireless system.
2 While pressing the stop button (e.g. [
∫]) on the home theater
unit, press the numbered button [2] on the remote control
until “P” lights in the home theater unit’s display.
3 While “P” is displayed, press
[I/D SET] on the rear of the
additional wireless system.
≥The indicator on the
additional wireless system
turns green.
≥If “P” goes off before you
press [I/D SET], repeat
step 2 and then continue
the procedure.
4 While pressing the stop button on the home theater unit,
press the numbered button [2] on the remote control.
5 Turn off and on the additional wireless system.
≥Make sure the indicator on the additional wireless system
lights up green.

Use a pointed object.
SH-FX71_RQTX1131-B_En.book Page 10 Thursday, January 14, 2010 5:18 PM