24
11 The exchange method of cast heater
1 Remove terminal for complete power and body
•
Refer to the exchange method of base for control PCB (See item 1 to 4, P13), remove the terminal and body.
2 Remove the cast heater
•
Remove the fi xing screws (×2) of cast heater.
• Take out the cast heater from inner enclosure.
2 Reassembly
•
Reassemble the new cast heater in reverse order for disassembly.
NOTES:
•
Refer to P5 for wiring connection.
• When assembling, make sure to paste the fl ame retardant tape on the initial position as before.
IP3830_SR-DF101_Eng_19_121224.in章节1:24 章节1:24 2012-12-24 17:19:45
To Next Page
Loading...
