Panasonic SR-TMG18

- 11 -
SR-TMG10 / TMG18
4.6 Disassembly a control unit
1. Pull out the hinge shaft.
2. Pulling out wiring for lid heater
and then pulling out outer lid ass’y.
3. Loosen a screw for bottom frame.
4. Loosen a screw for P.C.B. base 2 pcs.
5. Use a screwdriver to pry bottom frame.
6. Pulling out body from upper frame.
7. Pulling out a switch ass’y.
8. Loosen screw for wiring.
9. Loosen a screw for P.C.B. from
P.C.B. base.
Screw