Automatically searches and adds receivable channels to memory.
_Select "ANT In" _-(Select Cable orAntenna
_2_Select "Mode" ÷SelectAII orAnalog
All: Analog and digital
Analog: Analog only
_3_Select "Start scan"
Settings are made automatically
@After completing the setting,
select "Apply". (see below @).
@All previously memorized
channels are erased.
Use this procedure when changing setting of recewing channels or changing the channel display.
Also, use to add or delete channels from channel list manually.
_0Select "Edit" _3_Ed it
No
select
next
<2)Select the item to be edited
/F_ 0)select item to edit
__'_ (Caption/Favorite/Add)
Add
@Caption:
Changes the station identifier
@Favorite:
Registers channel to Favorites List
@Add:
Adds or deletes channels
@Caption
[ Preset ]
Select the station identifier
[ Caption detail ]
Rename (maximum 7 characters available)
_#Favorite
[ Favorite ]
Select the number
@Add
Press "OK" button to select "Yes (add)" or "No
(delete)"
@Select "Apply"
Press to move cursor to "Apply"
RETURN /_--\
oK _ ok
EXIT (to enter your
....._# \_/ program)
Check the signal strength if interference is found or freezing occurs on a digital image.
CH
nat intensity
channel
@If the signal is weak, check the antenna.
If no problem is found, consult your
local dealer.
Note
@Not available if "Cable" is selected in "ANT In"
(see above).
@Effective only for digital antenna channels.
m
93
tm
03
G:3
©
::3-
93
@If"Channel lock" (p. 16) is activated and "Auto", "Manual" or "Signal meter" is selected, "Enter password." will be displayed. 19
To Next Page
Loading...
