Panasonic TC-P50X5 - Page 16

16
7.2.10. Remove the M8 nut metals
1. Remove the screw (×1 each) and remove the M8 nut
metals.
7.2.11. Remove the K-Board
1. Remove the screw (×1 ).
2. Disconnect the connector (K1) and remove the K-Board
from the LED panel.
7.2.12. Remove the Cabinet assy from the
Plasma panel section.
1. Place the Cabinet assy on a flat surface of a table
(covered by a soft cloth) and a cushion.
2. Remove the screws (×2 ).
3. Remove the Cabinet assy from the Plasma panel section.
7.2.13. Remove the Contact metal bottom
1. Remove the screws (×8 ) and remove the Contact
metal bottom.
7.2.14. Remove the C1-Board
1. Disconnect the flexible cables (CB1, CB2, CB3 and CB4).
2. Disconnect the flexible cable (C10).
3. Remove the screws (×4 ) and remove the C1-Board.
7.2.15. Remove the C2-Board
1. Disconnect the flexible cables (CB5, CB6, CB7 and CB8).
2. Disconnect the flexible cables (C20 and C21).
3. Disconnect the connector (C25).
4. Remove the screws (×4 ) and remove the C2-Board.