Panasonic TH-37PA60E

6.19. Remove the S-Board
1. Remove the screw (×2 ) and remove the S-Board unit.
2. Unlock the cable clampers to free the cable.
3. Disconnect the coupler (S1).
4. Remove the screws (×2
) and remove the S-Board.
6.20. Remove the K-Board
1. Unlock the cable clampers to free the cable.
2. Disconnect the coupler (H53). (see section 6.5.)
3. Remove the screws (×3
) and remove the K-Board.
6.21. Remove the stand brackets
1. Remove the plasma panel section from the servicing stand
and lay on a fiat surface such as a table (covered) with the
plasma panel surface facing downward.
2. Remove the stand brackets (left, right) fastening screws (×6
each) and remove the stand brackets (left, right).
16
TH-37PA60E / TH-37PD60B / TH-42PA60E / TH-42PD60B