8 Self Check
1. Self-Check is used to automatically check the bus lines and hexadecimal code of the TV set.
2. To get into the Self -Check mode press the Down (
) button on the customer controls at the front of the set, at the same
time pressing the Information button on the remote control, and the screen will show :
If the CCU ports have been checked and found to be incorrect or not located then “--” will appear in place of “O.K.”.
Display Ref.No. Description Board
MEM IC1102 EEPROM DG-Board
GC5 IC4037 GC5 Processor DG-Board
AVSW1 IC3005 Video SW H-Board
AVSW2 IC2105 Audio SW H-Board
Tun1 TU001 Tuner TA-Board
VIF - - -
MSP IC2106 Multi Sound Processor H-Board
PANEL IC9003 Convert Micon D-Board
IPC IC8013 PEAKS Lite XV-Board
HDMI IC4026 HDMI I/F Receiver DG-Board
ADV IC4019 10bit A/D DG-Board
24
TH-37PA60E / TH-37PD60B / TH-42PA60E / TH-42PD60B
To Next Page
Loading...
