Panasonic TH-37PX60U - Table of Contents

Table of Contents
3
Subject Page
Troubleshooting Shutdown Problems 5
Power LED’s Response to Shutdown Operation 6
LED blinks 1 time 7
LED blinks 2 times (TH-37PX60, TH-42PD60U, TH-42PX60U \ 600U) 8
LED blinks 2 times (TH-50PX60U\600U, TH-58PX60U\600U, TH-
65PX600U)
9
LED blinks 3 times 10
LED blinks 4 times 11
LED blinks 5 times (Quick Troubleshooting) 12
LED blinks 5 times (TH-37PX60U, TH-42PX60U and TH 42PX600U) 13
LED blinks 5 times (TH-50PX60U and TH 50PX600U) 14
LED blinks 5 times (TH-58PX60U and TH 58PX600U) 16
LED blinks 5 times (TH-65PX600U) 18
LED blinks 6 times 20
LED blinks 7 times (All Models Except TH-58PX60/600U) 21
LED blinks 7 times (TH-58PX60/600U) 22
LED blinks 8 times 23
LED blinks 9 times 24
LED blinks 10 times before pressing the power button 25
LED blinks 10 times after pressing the power button 26
LED blinks 11 times 26
LED blinks 12 times (TH42PD60U, TH-37/42/50PX60U) (TH-
65PX600U)
28
Subject
Page
LED blinks 12 times (TH42/50/58PX600U)
29
Dead
30
No Picture from one or all inputs (OSD and Sound OK)
31
No Picture\No OSD
32
No Sound (TH-42PX600U)
33
Troubleshooting for Picture Problems
36
Diagnostic Method for Troubleshooting PDP Television
36
Diagnosis by Test Pattern When OSD is Available
37
Diagnosis by Removing the D5 Connector
38
Troubleshooting for Picture Trouble
39
Diagnosis for Picture Problem (All Over the Screen)
40
Diagnosis of Vertical Line Problem
44
Picture Trouble at Upper or Lower half
45
Picture Trouble at Right or Left half (50 Inch)
46
Picture Trouble at Right or Left half (42/37 Inch)
47
Picture Trouble in 50 Inch Models
48
Picture Trouble all Over the Screen
49
Examples of Symptoms and Remedies
50
Reset and Self-check Procedure
57
Driver Setup Adjustment
58
Board Layout and Part Numbers
63
Introduction
<Introduction>
1. Basic concept of how to determine the defective board
1) Verification of voltages
Normally, when there is a power problem, shutdown occurs immediately.
So, to resolve a power problem, voltage checks are necessary before shutdown.
2) Check if the power comes up after disconnecting the board under suspicion.
If power comes up (*) after disconnecting a board, the board is defective.
(*) “Power comes up” equals “no shutdown”.
2. Troubleshooting Video and Audio problems
3. Examples of video problems
4. Adjustment after PCB exchange
1) After exchanging the following boards, voltage adjustment is required.
P board, SC board, SS board => Please refer to the “Service Manual”.
4