32
Select Signal from the “Setup” menu during RGB input signal.
Press to adjust.
Setting RGB sync signal:
Confirm that the input is set to RGB input (this setting is valid only for RGB input
signal).
H & V: The H and V sync signals are input from the HD/VD connector.
on G: Uses a synchronized signal on the Video G signal, which is input
from the G connector.
CS: Uses a synchronized signal of Composite Sync input.
Displays the H (Horizontal)/V (Vertical) frequencies.
This display is valid only for RGB input and DVI input signal.
Display range:
Horizontal 15 - 110 kHz
Vertical 48 - 120 Hz
H-Freq. (kHz)/V-Freq. (Hz)
Setup for input signals
Sync
Press to exit from adjust mode.
Press
(ACTION) button
Sync
H & V
Sync
CS
Sync
on G
H
-
Freq. kHz
V
-
Freq. Hz
31.5
60.0
Signal
[
RGB
]
Sync
H
-
Freq. kHz
V
-
Freq. Hz
H & V
31.5
60.0
R
Setup 1/2
Signal
Screensaver
Input label
Component/RGB-in select
RGB
RGB1
OSD Language
English
(
UK
)
Power save
Off
Standby save
On
Power management
Off
Note:
Sync cannot be adjusted while a DVI signal is being applied.
Note:
It is not possible to use a composite video signal to synchronise on RGB picture ( for example, RGB from a DVD
player).
To Next Page
Loading...
