Panasonic TH-42PX50U - Adjustments; Driver Set-Up

Adjustments
Panel Label information
Figure 51
Driver Set-up
Item / Preparation
Input an APL 100 % white signal.
Set the picture controls to:
Picture mode = Normal
White Balance = Cool
Aspect = 16:9
Adjustments
To perform the following adjustments, please refer to the panel information label located
on the heat sink of the panel. See Figure 51 for more information about the panel label.
TH-42PX500
Name Test point Voltage Volume
Vsus
TPVSUS
(SS-BOARD)
Vsus ± 2V* VR351
(P-BOARD)
Ve
TPVE
(SS-BOARD)
Ve ± 1V* VR6145
(SS-BOARD)
Vset
TPVSET
(SC-BOARD)
240 V ± 7V Verify Only
Vad
TPVAD
(SC-BOARD)
-105 ± 1V VR6477
(SC-BOARD)
Vda
TPVDA
(SS Board)
70V ± 1V Verify only
VSCN
TPVSCN
(SC-BOARD)
Vad+130V ± 4V Verify only
* Refer to the panel label for the exact value
Table 9
TH-50PX500
Name Test point Voltage Volume
Vsus
TPVSUS (SS-BOARD) Vsus ± 2V* VR351
(P-BOARD)
Ve
TPVE (SS-BOARD) Ve ± 1V* VR6250
(SS-BOARD)
Vset
TPVSET (SC-BOARD) 225 V ± 7V Verify Only
Vad
TPVAD (SC-BOARD) -90 ± 1V VR6801
(SC-BOARD)
Vda
TPVDA (SS Board) 75V ± 1V Verify only
VSCN
TPVSCN (SC-BOARD) Vad+130V ± 4V Verify only
* Refer to the panel label for the exact value
Table 10
58