6.15. Remove the speaker L, R
1. Disconnect the connector (A12). (See section 6.4.)
2. Remove the screws (×4
each) and remove the speaker
L, R.
6.16. Remove the stand brackets
1. Remove the plasma panel section from the servicing stand
and lay on a flat surface such as a table (covered) with the
plasma panel surface facing downward.
2. Remove the stand brackets (left, right) fastening screws (×6
each) and remove the stand brackets (left, right).
6.17. Remove the S-Board
1. Remove the screws (×2 ) and remove the S-Board metal
frame.
2. Disconnect the connector (S2).
3. Remove the screws (×2
) and remove the S-Board.
6.18. Remove the K-Board
1. Remove the S-Board. (See section 6.17.)
2. Unlock the cable clampers to free the cable.
3. Disconnect the connectors (A1). (See section 6.4.)
4. Remove the screws (×2
) and slide to the right to remove
the K-Board.
5. Disconnect the connectors (K1 and K2) and remove the K-
Board.
12
TH-42PX75U
To Next Page
Loading...
