16
Selecting the input signal
Notes:
• Selecting is also possible by pressing the INPUT button on the
unit.
• Select to match the signals from the source connected to the
component/RGB input terminals. (see page 37)
Press to select the input signal to be played back from the equipment which has
been connected to the Display.
Input signals will change as follows:
PCHDMI1 HDMI2 Component*
VIDEO DVI
HDMI1: HDMI input terminal in AV IN (HDMI1).
HDMI2: HDMI input terminal in AV IN (HDMI2).
VIDEO: Video input terminal in VIDEO.
Component*: Component or RGB input terminal in COMPONENT/RGB IN.
PC: PC input terminal in PC IN.
DVI: DVI input terminal in DVI-D IN.
* “Component” may be displayed as “RGB” depending on the setting of
“Component/RGB-in select”. (see page 37)
When an optional Terminal Board is installed:
PCVIDEO
HDMI1 HDMI2
DVI
ComponentSLOT INPUT
SLOT INPUT: Input terminal in Terminal Board
Note:
When a Terminal Board incompatible with the Display is installed,
“Non-Compatible Function Board” is displayed.
To Next Page
Loading...
