44
Options Adjustments
Item Adjustments
Power ON Screen
Delay
Off
1 2 3.... 30
You can set the power-on delay time of the displays to reduce the power load, when you press
to
turn on the multiple displays that are set together, for example, on MULTI DISPLAY system.
Set each display’s setting individually.
Off: The display will be turned on at the same time as
is pressed.
1 to 30 (sec.)
: Set the power-on delay time (second).
After pressing , the display will be powered on with time delay depending on this setting.
Notes:
• During this function is working, the power indicator is blinking green.
• This function also works when the power recovers from failure or after plugging off and in again the
power cord.
Clock Display
Off: Not display the clock.
On: Display the clock.
The clock is displayed at the lower left of the screen when
button is pressed.
Note: When “PRESENT TIME Setup” is not set, the clock is not displayed even
if “Clock Display” is “On”. (see page 27)
10:00
Power On Message
(No activity power
off)
Whether to show/hide No activity power off Precautions at the time of power ON is set.
On: The warning precautions are shown at the time of power ON.
Off: The warning precautions are not shown at the time of power ON.
Note: This setting is enabled only if “No activity power off” is “Enable” (see page 31).
Function button assign 1
Function button assign 2
Set the functions that operates when is pressed.
Signal: The “Signal” menu is displayed.
Screensaver: The “Screensaver” menu is displayed.
ECO menu: The “ECO Mode settings” menu is displayed.
Set up TIMER: The “Set up TIMER” menu is displayed.
Note:
Factory settings are as follows.
FUNCTION1 button: Signal
FUNCTION2 button: Screensaver
Use the FUNCTION button
The menu screen is displayed. (Example: Signal)
3D Y/C Filter
Colour system
Signal
On
Auto
Cinema reality
Off
[
AV
]
Noise reduction
Off
Press the FUNCTION button to exit from the menu.
Normalisation
When both main unit buttons and remote control are disabled due to the “Button lock”, “Remocon User level” or
“Remote ID” adjustments, set all the values “Off” so that all the buttons are enabled again.
Press the
button on main unit together with button on the remote control and hold for more than 5 seconds. The
“Shipping” menu is displayed and the lock is released when it disappears.
To Next Page
Loading...
