23
English
Select the language
Select [Home]
Select [Home] for use in a home viewing environment.
≥ [Shop] is for shop display.
≥ To change the viewing environment later on, the set
will need to have all settings initialised by accessing
[Shipping Condition].
Set up the network connection
Tick the TV signal mode to tune, and then select
[Start Auto Tuning]
Select your region (Satellite)
If tuning has failed check the Satellite cable, RF cable,
and the network connection, and then follow the on-
screen instructions.
≥ The TV goes into Standby mode when no signal is
received and no operation is performed for 10 minutes
if [No signal Power off] in the Timer menu is set to [On]
(factory setting).
≥ To retune all channels
[Auto Tuning] in [Tuning Menu] ([Setup] menu)
≥ If no satellite channel is found, set [LNB Band
Frequency] to suit your environment.
[LNB Configuration] in [Satellite TV Tuning
Menu] ([Setup] menu)
≥ To add the available TV signal mode later
[Add TV Signal] in [Tuning Menu] ([Setup]
menu)
≥ To initialise all settings
[Shipping Condition] in [System Menu] ([Setup]
menu)
Watching TV
1 Turn power on
or
2 Select the mode
≥ Selectable modes vary depending on the stored
channels.
3 Select a channel
or
≥ To select a channel position with 2 or more-digit, e.g.
399
Auto Tuning is now complete and the
TV is ready for viewing.
(Remote Control)
≥ Mains power On / Off switch should be on.
(p. 21)
TH-48_55_65LZ980Z_Eng_TQB4GA0057.book 23 ページ ２０２２年４月２６日 火曜日 午後２時３１分
To Next Page
Loading...
