Panasonic TH-50PV70L

6.15. Remove the stand brackets
1. Remove the plasma panel section from the servicing stand
and lay on a flat surface such as a table (covered) with the
plasma panel surface facing downward.
2. Remove the stand brackets (left, right) fastening screws (×5
each) and remove the stand brackets (left, right).
6.16. Remove the C1-Board
1. Remove the tuner unit. (See section 6.5.)
2. Remove the stand bracket (L). (See section 6.15.)
3. Remove the flexible cables holder fastening screws (×10
).
4. Disconnect the flexible cables (CB1, CB2, CB3, CB4 and
CB5).
5. Disconnect the flexible cables (C10 and C11).
6. Remove the screws (×5
) and remove the C1-Board.
6.17. Remove the C2-Board
1. Remove the tuner unit. (See section 6.5.)
2. Remove the flexible cables holder fastening screws (×6
).
3. Disconnect the flexible cables (CB6, CB7 and CB8).
4. Disconnect the flexible cables (C20, C21 and C22).
5. Remove the screws (×4
) and remove the C2-Board.
6.18. Remove the C3-Board
1. Remove the tuner unit. (See section 6.5.)
2. Remove the stand bracket (R). (See section 6.15.)
3. Remove the flexible cables holder fastening screws (×6
).
4. Disconnect the flexible cables (CB9, CB10 and CB11).
5. Disconnect the flexible cable (C32).
6. Disconnect the connectors (C33 and C35).
7. Remove the screws (×4
) and remove the C3-Board.
6.19. Remove the front bracket
1. Disconnect the connector (H51). (See section 6.5.)
2. Remove the screws (×4
) and remove the front bracket.
14
TH-50PV70L