Panasonic TH-50PX75U - Remove the SS-Board; Remove the Stand Brackets; Remove the C1-Board; Remove the C2-Board

6.12. Remove the SS-Board
1. Disconnect the connectors (SS11, SS12 SS23, SS24,
SS33, SS34 and SS35).
2. Disconnect the flexible cables (SS54 and SS55).
3. Remove the screws (×7
) and remove the SS-Board.
6.13. Remove the stand brackets
1. Remove the plasma panel section from the servicing stand
and lay on a flat surface such as a table (covered) with the
plasma panel surface facing downward.
2. Remove the stand brackets (left, right) fastening screws (×5
each) and remove the stand brackets (left, right).
6.14. Remove the C1-Board
1. Remove the tuner unit. (See section 6.4.)
2. Remove the stand bracket (R). (See section 6.13.)
3. Remove the flexible cables holder fastening screws (×10
).
4. Disconnect the flexible cables (CB1, CB2, CB3, CB4 and
CB5).
5. Disconnect the flexible cables (C10 and C11).
6. Remove the screws (×5 ) and remove the C1-Board.
6.15. Remove the C2-Board
1. Remove the tuner unit. (See section 6.4.)
2. Remove the flexible cables holder fastening screws (×6
).
3. Disconnect the flexible cables (CB6, CB7 and CB8).
4. Disconnect the flexible cables (C20, C21 and C22).
5. Remove the screws (×4
) and remove the C2-Board.
12
TH-50PX75U