EN28
For Your Operating Convenience (continued)
Correcting the water
output display
There is a slight diff erence
between the water output
display and actual output
of water. (This depends
on the usage conditions,
water pressure and other
factors.) If there is a
signifi cant diff erence,
correct the water output
display.
Note
When is pressed in steps 5 to 7, the previous screen is restored. After the settings are completed, the
previous screen will not be restored even when the button is pressed.
Once the settings have been set, they will be stored in the memory until other settings are established (until
they are changed).
Displays on the screens indicated will be in Chinese even if the English display mode is established.
Control panel
LCD display
Measuring the water output volume (continued)
After performing steps 1 to 4 of “Setting the diff erence in height between the
main spout and acidic water spout” on P. EN27, perform the steps below.
5
Press , and
select “ 補正 ”.
6
Press .
7
Press ,
and select one of the
correction values listed
in the table.
e.g.) When the water output
display is 0.5 liter, and
the actual water output
is 0.6 liter (the water
output is about 20% more
than the display)
Diff erence between
water output displayed
and actual water output
Correction
value
When the actual water
output is about 20% more
than the display
–20%
When the actual water
output is about 10% more
than the display
–10%
When the diff erence is
less than 10%
±0% *
When the actual water
output is about 10% less
than the display
+10%
When the actual water
output is about 20% less
than the display
+20%
*: No compensation
8
Press .
<The setting is fi nished>
9
Press , and
select “ 是 ”.
10
Press .
After about
3 seconds
Compensation now
set to –20%
e.g.)
Measurement condition setting
Height diff erence
Compensation
Compensation
–20%
–10%
±0%
Compensation
–20%
–10%
±0%
Exit the setting mode?
Yes
No
Exit the setting mode?
Yes
No
TK-AS66-ZEXEn.indb28TK-AS66-ZEXEn.indb28 2017/01/3015:04:192017/01/3015:04:19