63
Wireless LAN
z To connect to the access point for connection in the stealth mode (ANY access denied), perform the steps below.
A Click or on the notification area and click [Network and Sharing Center]-[Manage wireless networks].
B Click [Add] and select [Manually create a network profile].
C Add a check mark for [Connect even if the network is not broadcasting] and set the access point.
For further setting information, ask the system administrator or the person in charge of the network.
1 Click or on the notification area.
2 Click [802.11a Enabled] or [802.11a Disabled].
NOTE
z In some countries, communication using IEEE802.11a (5 GHz wireless LAN) standard is restricted by law.
z The Wireless Switch Utility icon ( or ) indicates the on/off status of wireless LAN and/or Bluetooth and/or wire-
less WAN, not the setting of IEEE802.11a.
z If IEEE802.11a is enabled or disabled while the computer is connected to an IEEE802.11b/g access point, the connec-
tion will be temporarily interrupted.
z You can also change the IEEE802.11a setting in [Device Manager].
A Click (Start) - [Computer] - [System properties] - [Device Manager].
z A standard user needs to enter an administrator password.
B Double-click [Network adapters] and double-click [Intel(R) Wireless WiFi Link 4965AG].
C Click [Advanced], and then select [Wireless Mode] in [Property].
D Select the settings in [Value] (e.g., [5. 802.11a/g]).
E Click [OK].
Enabling/Disabling the Wireless LAN Standard IEEE802.11a (802.11a)
To Next Page
Loading...
