28
1
Connect the external display to your computer
Do not shut down using the suspend or hibernation mode.
Power off your computer ( "Starting Up/Shutting Down")
Run the Setup Utility ( page 34)
Using and , select [Main]
Turn on the external display, then turn on your computer
with the display opened
3
1
2
3
External Display Port
Using an External Display
Select your external display
4
Set your external display for [Monitor] in [Start] - [Settings] - [Control
Panel] - [Display] - [Settings] - [Advanced Properties].
When a monitor that does not conform to the Plug & Play standards is
connected, select [Change] and make the monitor settings.
You can select either an external display, LCD or simultaneous with Fn
+ F3 .
In addition, you can set the display to use during start-up with the follow-
ing procedure.
For more detailed information, please refer to the operation manual of
the external display.
2
NOTE
Using and , select the display to use and
press Enter
Press F10 , then select [Yes]
5
Using and , select [Display] and press Enter
6
To Next Page
Loading...
