Panasonic Toughbook CF-27 Series

To Next Page

To Previous Page

Select [Start] - [Programs] - [Accessories] - [Direct Cable Connection]

Select [Host] or [Guest], then press [Next]

Select [Serial cable on COM4], then press [Next]

Press [Finish]

If [Serial cable on COM4] is not displayed, select [Install New Ports].

Data Communications

Infrared data communications will begin.

To process at a transfer speed of 4 Mbps, separate application software is necessary.

When you select [Start] - [Settings] - [Control Panel], and then select [Infrared], this will

give you the conditions for infrared data communications.

Do not use suspend and hibernation functions during communications.

Please refer to Windows help on how to use Direct Cable Connection.

Direct Cable Connection is not installed after reinstalling the computer, so add the

check mark

for [Dial-Up Networking] and [Direct Cable Connection] in [Communica-

tions] with [Windows Setup] in [Control Panel] - [Add/Remove Programs] and simply

follow the on-screen instructions.

Before data communications, please do the following.

Add the check mark for [Dial-Up Networking] in [Communications] with [Win-

dows Setup] in [Control Panel] - [Add/Remove Programs].

Select [Microsoft] for [Manufacturers:] and [File and printer sharing for Microsoft

Networks] for [Network Services:] in [Control Panel] - [Network] - [Add] - [Service].

Use Windows Explorer to set the folders for sharing on the host side.

NOTE

Infrared Data Communications

Panasonic Toughbook CF-27 Series - Page 32