17
Tuning menu – Manual tuning
Press the MENU button.
Move to choose Setup menu.
Access Setup menu.
Move to choose Tuning menu.
Access Tuning menu.
Move to choose Manual tuning.
Access Manual tuning.
Select the programme position to be tuned.
Press repeatedly until required station is found.
When the desired station is found, press the OK button to store.
The programme position will flash.
Press the EXIT button at any time to go back to watching TV.
It is also possible to use the control panel buttons on the top of your TV to tune individual programme positions:
Press the F button until Tuning mode is reached.
Press the
–
/ or +/ button to access Tuning mode.
Press the TV/AV button to move between Change
programme and Search.
Press the –
/ or +/
button to change programme
position or start search.
When the desired station is found, press the STR
button to store.
The programme position will flash.
Repeat above procedure to tune additional
programme positions.
Press the F button at any time to go back to watching
TV.
Note:
If your VCR is connected to this TV by an RF cable only, choose programme position “0” to tune to the VCR
signals.
Manual tuning (via top panel)
It is possible to retune individual programme positions:
CH44
1
Manual tuning
21 68
-
, + : Search
TV / AV : Move cursor
STR : To store
F : To exit
STR F
-
/ + / TV / AV
To Next Page
Loading...
