18
Press the MENU button.
Move to choose Setup menu.
Access Setup menu.
Move to choose Tuning menu.
Access Tuning menu.
Move to choose Shipping condition.
Access Shipping condition.
Press OK to start.
Press again, to confirm, each time that you are asked, “Are you sure?”.
Switch the TV off at the mains power switch.
The next time you switch the TV on, Auto setup will begin. Stations
will be located, sorted and stored ready for use. See page 16.
Shipping condition allows you to reset the TV to its original condition, i.e., no channels tuned in.
This is useful, for example, if you move to a different area when you will probably want the TV to tune itself to your
new local stations.
This can be done either through the Shipping condition menu or through the Auto setup menu.
The Shipping condition menu will reset all data, clearing all analogue tuning information and resetting all control
levels back to factory settings.
You may need to adjust your VCR or programme position “0” VCR after operating the Shipping condition menu.
Shipping condition
MENU
OK
Programme edit
Auto setup
Manual tuning
Shipping condition
Owner ID
Tuning menu
Access
Return Exit
Start
All tuning data will be erased
Are you sure ?
Are you sure ?
Shipping condition
TV
OK
123
456
789
C
0
N
To Next Page
Loading...
