Quick Start Guide
Programmes will appear immediately if your dealer has programmed
the TV for you.
If the TV has not been programmed for you then Auto setup will begin.
The TV will search for Analogue stations:
TV stations will be located, sorted into order and stored ready for use.
Analogue stations are sorted into channel order, but can be changed
to your preference. See page 14.
The sorted programme order depends upon the TV signal, the
broadcasting system, and reception conditions.
2
1
Connect the mains plug to the wall socket.
Press the
switch on the TV set to turn the
set on.
To switch the TV set to Standby mode, press
the
button on the remote control.
The TV set can be switched on by pressing
the
button again if it was in Standby mode.
TV
OK
123
456
789
C
0
N
Remote control signal sensor
CH44
EXIT : To exit
AUTO SETUP IN PROGRESS
SEARCHING : PLEASE WAIT
21 68
Stored CH44
DOWNLOAD IN PROGRESS
PLEASE WAIT
Programme : 63
Remote control unavailable
TV to VCR or DVD Recorder Download
If a “Q-Link”, “NEXTVIEWLINK” or compatible recording device has
been connected to a Scart terminal before starting Step 1,
programme information will be downloaded to that device.
3
The analogue programme positions will be downloaded to the recording device, in the same order as stored
in the TV. See page 20.
Not all VCRs / DVD Recorders support this download of programme information, some may require to be
started manually.
Refer to the recording device’s operating instruction book.
If a recording device other than those described above has been connected, then there will be no download
operation.
Notes:
• If the recording device has not accepted download data from the TV, you may need to select the Download
option from the device’s menu system. Refer to the recording device’s operating instruction book.
• If Q-Link is not operating correctly, check the following :
The Scart cable is connected to the TV’s Scart terminal, AV1 or AV2, and correctly setup in the menu.
The Scart cable is connected to the recording device’s compatible (Q-Link, NEXTVIEWLINK or similar
technology) Scart terminal.
The Scart cable is a “fully wired” type.
• For further information on Q-Link and connecting equipment, see page 20, 28, 30.
Power Indicator
Standby : Red
On : No Light
To Next Page
Loading...
