English
Pull open
Hook
Note the correct
polarity (+ or -)
Close
When pressing 4, 5, 6 buttons, the control panel
guide appears on the right side of the screen for
3 seconds to highlight which button has been
pressed.
5
6
7
4
123
Rear side of the TV
Do not place any objects between the TV remote
control signal receiver and remote control.
Senses brightness to adjust picture quality when
[Ambient Sensor] in the Picture Menu is set to
[On].
Standby
On
Standby with some functions (recording, etc.)
active
The LED blinks when the TV receives a command
from the remote control.
Press repeatedly until you reach the desired mode.
Press and hold for about 3 seconds to display main
menu.
(when in the menu system)
Cursor Up / Down (when in the menu system)
Cursor Left / Right (when in the menu system)
Use to switch the mains power.
To turn Off the apparatus completely, you must pull
the mains plug out of the mains socket.
[
]: Standby / On
To Next Page
Loading...
