- 84 -
■ DVB-C, DVB-T, Analogue
1. Select Auto Setup with / and press OK to access.
2. Set DVB-C Auto Setup Settings with
/ / / and press OK to store.
(DVB-C)
●
Scan Mode
Full:
Scans the whole frequency range.
Quick:
Scans the suitable frequency in your country.
●
Normally set Frequency, Symbol Rate and Network ID to Auto. If Auto
is not displayed or if necessary, enter each value specified by your
cable provider with Numeric buttons.
●
After settings, select Start scan with / and press OK to search.
3. The confirmation screen is displayed and press OK to start Auto Setup.
(Settings are made automatically.)
●
When the operation is completed, the channel at the lowest position will
be displayed.
■ Auto Setup using the buttons on the TV
1. Press and hold INPUT/OK/HOLD for MENU button for 3 seconds to
display the menu.
2. Set Auto Setup with following control panel buttons.
●
Move the cursor / select from a range of options / select the menu item
(up and down only)
●
Access the menu / store settings after adjustments have been made or
options have been set with INPUT/OK/HOLD for MENU button
To Next Page
Loading...
