- 85 -
Manual Tuning
●
Normally use Auto Setup or Update Channel List to retune DVB channels.
●
If tuning has not been done completely or for adjusting the direction of the
aerial, use this function. (DVB)
●
All DVB channels found will be added to Channel List.
■ DVB-C
1. Enter the frequency with Numeric buttons.
●
Normally set Symbol Rate and Service ID to Auto.
2. Select Start scan with
/ and press OK to search.
■ DVB-T
1. Select a channel with / and adjust frequency with / for each
channel.
●
Set where the level of Signal Quality becomes the maximum.
2. Press OK to search.
■ Analogue
Set Analogue channel manually after Auto Setup.
●
Set Sound System and Colour System, and then perform this function.
Normally set Colour System to Auto.
– SC1: PAL B, G, H / SECAM B, G
– SC2: PAL I
– SC3: PAL D, K / SECAM D, K
– F: SECAM L, L’
1. Select the channel position with Numeric buttons.
2. Select the channel with Channel Up / Down.
3. Search with / .
To Next Page
Loading...
