Panasonic TX-40FXT686 - Timer Programming

Timer Programming
This function allows you to select programmes that you want to record to the
USB HDD.
1. Display TV Guide with GUIDE.
2. Select the forthcoming programme and press OK to access.
●
You can also set a timer event pressing .
●
To check / change / cancel a timer event
Recording > Timer Programming > Editing Timer Programming
●
LED turns to orange in Standby mode when Timer Programming is set.
●
To return to TV Guide
BACK/RETURN
●
If you select the current programme, a confirmation screen asking
whether you want to watch or record the programme appears. Select
Timer Programming and press OK to set USB HDD Rec. to record from
the time you finish the timer event setting.
●
is displayed on the TV Guide screen if Timer Programming is set
from TV Guide.
●
Depending on the country you select, you can set Signal Supported
Recording (see below).
= Note =
●
Not valid in Analogue
●
Timer Programming only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
No other channels can be selected while recording of Timer Programming
is in progress. (Only for single tuner model)
●
When recording programmes to the USB HDD, be sure to format the USB
HDD and enable it to record in USB Device Setup.
Recording > USB HDD setup
●
To set timer programming events of this TV on the network equipment
(smartphone, etc.) from outside the home network
Recording > Timer Programming > Remote recording
- 102 -