23
English
Set up the network connection
Tick the TV signal mode to tune, and then select
[Start Auto Setup]
≥ [Satellite Antenna Setup]
Ensure the satellite connections are completed (p. 14)
and select the tuner mode ([Dual Tuner] / [Single
Tuner]).
Select your region
Space Tune Adjustment
If tuning has failed check the Satellite cable, RF cable,
and the network connection, and then follow the on-
screen instructions.
≥ The TV goes into Standby mode when no operation is
performed for 4 hours if [Auto Standby] in the Timer
menu is set to [On] (factory setting).
≥ The TV goes into Standby mode when no signal is
received and no operation is performed for 10 minutes
if [No signal Power off] in the Timer menu is set to [On]
(factory setting).
≥ To retune all channels
[Auto Setup] in [Tuning Menu] ([Setup] menu)
≥ To add the available TV signal mode later
[Add TV Signal] in [Tuning Menu] ([Setup]
menu)
≥ To initialise all settings
[Shipping Condition] in [System Menu] ([Setup]
menu)
Watching TV
1 Turn power on
or
2 Select the mode
≥ Selectable modes vary depending on the stored
channels and selected country.
3 Select a channel
or
≥ DVB and Satellite channel position begin from number
1 upward. Analogue channel position numbers are in
the 0 - 99 range.
Auto Setup is now complete and the TV
is ready for viewing.
(Remote Control)
≥ Mains power On / Off switch should be on.
(p. 21)
TX-77LZ2000B_TQB4GA0126_eng.book 23 ページ ２０２２年２月１７日 木曜日 午前１０時８分
To Next Page
Loading...
