- 43 -
●
If a VCR is connected only with the RF cable in Analogue mode, edit VCR.
Auto Setup
Automatically retunes the channels received in the area.
●
This function is available if channel tuning is already performed.
●
Only the selected mode is retuned. All the previous tuning settings are
erased.
●
If Child Lock PIN number has been set, the PIN number is required.
Functions Child Lock PIN number
●
If tuning has not been done completely, set Manual Tuning.
Watching Tuning and editing channels Manual Tuning
■ DVB-C, DVB-T, Analogue channels
1. Select Auto Setup with / and press OK to access
2. Set DVB-C Auto Setup Settings with
/ / / and press OK to store
(DVB-C)
●
Scan Mode
Full:
Scans the whole frequency range.
Quick:
Scans the suitable frequency in your country.
●
Normally set Frequency, Symbol Rate and Network ID to Auto. If Auto
is not displayed or if necessary, enter each value specified by your
cable provider with numeric buttons.
●
After settings, select Start scan with / and press OK to search.
3. The confirmation screen is displayed and press OK to start Auto Setup
(Settings are made automatically)
●
When the operation is completed, the channel at the lowest position will
be displayed.
■ Auto Setup using the buttons on the TV
1. Press and hold INPUT/OK/HOLD for MENU button for 3 seconds to
display the menu
2. Set Auto Setup with following control panel buttons
●
Move the cursor / select from a range of options / select the menu item
To Next Page
Loading...
