2...
...
3...
...
4...
...
Changes will be lost. Continue?
Editing and Setting Channels
The current channel settings can be changed according to your needs and reception
conditions.
2
1
3
4
5
■
Press to exit from
menu screen
Display menu
Select “Setup”
Select “Program channel”
Select the function
Set
■
To reset the settings of setup menu
Select “Reset” in Setup menu ( ) and press OK
Input your 4-digit password with number buttons
Select “YES” on the confirmation screen and press OK
next
select
next
select
Auto
Set
automatically
Manual
Set
manually
Signal
meter
Check
signal
strength
Automatically searches and adds active channels to memory.
Select “ANT in”
Select “Auto”
•
Favorite
next
select
Use this procedure when changing setting of receiving
channels or changing the channel display.
Also, use to add or skip channels from channel list
manually.
Select “Edit”
Edit
•
Caption
select
next
select item to edit
(Caption/Favorite/Add)
next
Select the item to be edited
Caption
Favorite
Add
•
Caption:
Changes the station identifier
•
Favorite:
Registers channel to Favorite
List
•
Add:
Adds or skips channels
Check the signal strength if interference is found or freezing occurs on a digital image.
change channel
ok
Signal intensity
•
Not available if “Cable” is selected in “ANT in”
(see above).
•
Effective only for digital antenna channels.
•
If the signal is weak, check the antenna.
If no problem is found, consult your
local dealer.
Select “Apply”
•
Add
Press OK to select “Yes (add)” or “No (skip)”
Select the number
Rename (maximum 7 characters available)
Select the station identifier
select
change
set/next
select
next
Note
Set favorite
Caption detailCaption
Select Cable or Antenna
(p. 17)
•
If “Lock” (p. 30) is activated and “Auto”, “Manual” or “Signal meter” is selected, “Enter password.” will be displayed.
Settings are made automatically
Select scanning mode (p. 17)
ok
select
•
After completing the setting, select “Apply”. (see below
To Next Page
Loading...
