Check that the Network settings are as shown below, and then start "Connection test".
d_ Select "Connection test" and press OK _2_Displayed Connection test screen
(It takes a while to cancel the test.)
_ Complete Connection test
Success->Completion screen is displayed.
Error-->Follow the directions on screen to complete the setting.
IfyouperformtheProxysettings,checktheProxyaddressandtheProxyportnumber.
Select Network type (Ethernet cable/Wireless (WiFi))
This setting is performed only when "Wireless (WiFi)" is selected in "Network connection" above.
Press "Wireless network", displayed screen
(only when "---", "No adapter" or "None" is displayed)
Set the following connection.
Please select the connection with your wireless LAN adapter and Access point.
_) Follow the directions on screen to complete the setting
WPS(Wi-FiProtectedSetupusingpushbutton):
Wi-FiProtectedSetupisaneasysettingof the Wi-FiAlliance'scertification.
Youcanconnectthe Accesspointto pressthe buttons.
WPS(Wi-FiProtectedSetupusingPIN number):
Setthe PINcodethatis displayedonthe TVontheaccesspoint.
wPs(Wi.FiProtectedSetupusingpushbutton) (Formore detailsonsettingof Accesspoint,pleasereferto operating
manualforthe Accesspoint.)
Searchforwirelessnetworks:
Selectan accesspointfromthe onessearchedfor automatically,and
configurethesettingsas instructedon the screen.
Manualsettings:
ManuallysetSSID,Securitytype, andEncryptiontypeto matchthe
settingsofthe accesspointtowhichto connect.
Whenconnectingby11n(5 GHz),select"AES"as the Encryptiontype for
the wirelessLAN.
• Displayed Connection status with an Access point
- - - : Connect with LAN cable
No adapter: Wireless LAN adapter is not installed.
None: There are no settings to connect Access point.
Connecting...: Currently connected to Access point.
If "Connected" is not displayed after a while, set
the access point connection settings again.
Connected: Complete connection.
• Displayed "Current settings and status" screen
(only when "Connected" or "Connecting..." is displayed)
You can confirm the AP connection status.
(SSlD/Wireless type/Security type/Encryption type/Connection status/Signal strength)
Press "Wireless network" _2_When you change "Wireless network" -->Press "No"
Follow the directions on screen to complete the setting.
You need to be "Connected" to use network devices.
Please set Access point settings to "Connected".
(example)
@The Network settings become effective when you close the menu and run "Connection test".
@
Z
©
U_
d)
_q.
G:3
Co
41
To Next Page
Loading...
