Set all channels automatically
Auto Tuning
Automatically retune all channels received in the area.
Start “Auto Tuning” Settings are made automatically
All the previous tuning settings are erased. z
When the operation is completed, the channel at channel position “1” will be displayed. z
Search begins in the order from the lower channels to the higher channels. Channels received during this z
process are added to the list. (p. 24)
If tuning has not been done completely z ¨ “Manual Tuning” (below)
For Auto Tuning, using the buttons on the side panel of the TV (p. 8)
1
Press repeatedly until “Auto Tuning” appears
2
Access “Auto Tuning”
3
Start “Auto Tuning”
To return to TV z ¨
Set channels manually
Manual Tuning
Fine Tuning
Use to make small adjustments to the tuning of an individual channel (affected by weather conditions, etc.)
Manual Tuning
Set channel manually after Auto Tuning.
Set Sound System and Colour System, and then perform this function.
z
Normally set Colour System “Auto”.
If a VCR is connected only with the RF cable, select channel position “0”. z
To Next Page
Loading...
