Panasonic WH-SXC09F3E8 - Page 9

9
English
Dealer
Operation/settings to be done only by the authorised dealer/specialist.
User
Operation/settings to be done by the authorised dealer/specialist or user.
Dealer
System temperature setting
Temperature setting Display
The system controls the temperature for each menu based on the
outdoor ambient temperature.
• To set or change the temperatures, make sure to contact your
nearest authorised dealer.
1
Press and hold
for 5 seconds to enter the
temperature range setting mode.
(The display shows SETTING.)
2
Press
or to select a menu.
3
Press
to enter the menu.
4
Press
or to set the desired temperature.
5
Press
to confirm the setting.
• Repeat steps
2
to
5
to set other menus.
User
Checking the temperature range
1
Press and hold
for 5 seconds to enter the temperature range setting mode.
2
Press or to select a menu.
• Press
to exit.
Menu
Temperature
setting
Display
Setting of low outdoor ambient temperature. -15 °C ~ 15 °C
HEAT
Setting of high outdoor ambient temperature. -15 °C ~ 15 °C
Setting of water outlet temperature at low outdoor ambient
temperature.
25 °C ~ 55 °C
Setting of water outlet temperature at high outdoor ambient
temperature.
25 °C ~ 55 °C
During HEAT mode, the water outlet
temperature is adjusted as is shown the
diagram on the right.
It is performed within the preset temperature
range.
<Water outlet
temperature>
<Outdoor ambient temperature>
max. water temp.
min. water temp.
Setting of outdoor ambient temperature to turn OFF heating
operation during HEAT mode.
5 °C ~ 35 °C HEAT
Setting of outdoor ambient temperature to turn ON the backup
heater.
-15 °C ~ 20 °C HEATER
Setting of water outlet temperature during *
1
COOL mode. 5 °C ~ 20 °C
*
1,
*
2
COOL
Setting of sanitary water tank temperature. 40 °C ~ 75 °C TANK
*
1
The system is locked to operate without COOL mode. It can be unlocked only by authorized installers or our authorized service partners.
*
2
Only displayed when COOL mode is unlocked (Means when COOL mode is available).
How to use