Item Unit Indoor Unit
Performance Test Condition EN 14511
Outdoor Ambient °C
Cooling: 16 ~ 43
Heating: -28 ~ 25
Operation Range
Water Outlet °C
Cooling: 5 ~ 20
Heating: 20 ~ 55 (Below Ambient -15°C)
20 ~ 60 (Below Ambient -10°C)
Internal Pressure Differential kPa
Cooling: 36
Heating: 52
Condition
(Ambient/Water)
A35W7 A7W35 A2W35
dB (A) Cooling: 33 Heating: 33 —
Noise Level
Power Level dB Cooling: 46 Heating: 46 —
Height mm (inch) 892 (35-1/8)
Width mm (inch) 500 (19-11/16)
Dimension
Depth mm (inch) 340 (13-13/32)
Net Weight kg (lbs) 43 (95)
Liquid mm (inch) 9.52 (3/8)
Refrigerant Pipe Diameter
Gas mm (inch) 15.88 (5/8)
Inlet mm (inch) 28 (1-3/32)
Water Pipe Diameter
Outlet mm (inch) 28 (1-3/32)
Water Drain Hose Inner Diameter mm (inch) 15 (19/32)
Motor Type DC Motor
No. of Speed 7 (Software Selection)
Pump
Input Power W 92
Type Brazed Plate
No. of Plates 36
Size (W × H × L) mm 65 × 119 × 376
Hot Water Coil
Water Flow Rate l/min (m
3
/h)
Cooling: 28.7 (1.7)
Heating: 34.4 (2.1)
Pressure Relief Valve Water Circuit kPa Open: 300, Close: 266 and below
Flow Switch Electronic Sensor
Protection Device A Residual Current Circuit Breaker (40)
Volume I 10
Expansion Vessel
MWP bar 3
Capacity of Integrated Electric Heater kW 6.00
Note:
Cooling capacities are based on outdoor air temperature of 35°C Dry Bulb with controlled indoor water inlet
temperature of 12°C and water outlet temperature of 7°C.
Heating capacities are based on outdoor air temperature of 7°C Dry Bulb (44.6°F Dry Bulb), 6°C Wet Bulb
(42.8°F Wet Bulb) with controlled indoor water inlet temperature of 30°C and water outlet temperature of 35°C.
Specification are subjected to change without prior notice for further improvement.
Flow rate indicated are based on nominal capacity adjustment of leaving water temperature (LWT) 35°C and
T
= 5°C.
To Next Page
Loading...
