6
Note:
• Cooling capacities are based on outdoor air temperature of 35°C Dry Bulb with controlled indoor water inlet temperature of 12°C
and water outlet temperature of 7°C.
Input Power kW Cooling: 2.30
Heating: 1.59
Maximum Input Power For Heat Pump System kW 4.59
Maximum Input Power For Internal Heater
(Internal Heater + Tank Heater)
kW 3.00 (6.00)
Starting Current A 7.30
Running Current A Cooling: 10.40
Heating: 7.30
Maximum Current For Heat Pump System A 21.0
Maximum Current For Internal Heater
(Internal Heater + Tank Heater)
A 13.0 (26.0)
Power Factor % Cooling: 96
Heating: 95
Power factor means total figure of compressor and outdoor fan motor.
Power Cord Number of core -
Length m (ft) -
Thermostat Electronic Control
Protection Device Electronic Control
Item Unit Indoor Unit
Performance Test Condition EUROVENT
Operation Range Outdoor Ambient °C Cooling: 16 ~ 43
Heating: -20 ~ 35
Water Outlet °C Cooling: 5 ~ 20
Heating: 25 ~ 55
Internal Pressure Differential kPa Cooling: 16.8
Heating: 22.0
Noise Level dB (A) Cooling: 30
Heating: 30
Power Level dB Cooling: 43
Heating: 43
Dimension Height mm (inch) 892 (35-1/8)
Width mm (inch) 502 (19-3/4)
Depth mm (inch) 353 (13-29/32)
Net Weight kg (lbs) 45 (99)
Refrigerant Pipe Diameter Liquid mm (inch) 6.35 (1/4)
Gas mm (inch) 15.88 (5/8)
Water Pipe Diameter Inlet mm (inch) 28 (1-3/32)
Outlet mm (inch) 28 (1-3/32)
Water Drain Hose Inner Diameter mm (inch) 15.00 (19/32)
Pump Motor Type Capacitor Run Induction Motor (2.5 μF)
No. of Speed 3
Input Power W 100
Hot Water Coil Type Brazed Plate
No. of Plates 48
Size (W x H x L) mm 93 × 81 × 325
Water Flow Rate
l/min (m
3
/h)
Cooling: 17.6 (1.1)
Heating: 20.1 (1.2)
Pressure Relief Valve Water Circuit kPa Open: 190, Close: 183 and below
Flow Switch Magnetic Lead Switch
Protection Device A Residual Current Circuit Breaker (40)
Expansion Vessel Volume I 10
MWP bar 2
Capacity of Integrated Electric Heater kW 3.00
Item Unit
To Next Page
Loading...
