(10.2) White Balance 3200 ˚K Manual Offset B
Adjustment
Test Point: Video Output Connector
8 Aim the Camera at the White Chart or the White Paper.
8 Adjust data with the ARROW key so that the vector
positions at the center of the Vectorscope as shown in Fig.
4-1-10.
8 Repeat adjustment from (10.1) to (10.2) until the vector
positions at the center of the Vectorscope.
8 Press the ENTER key for the next adjustment.
(11.1) White Balance 6500 ˚K ATW Limit R
Adjustment
Test Point: Video Output Connector
8 Aim the Camera at the White Chart or the White Paper.
8 Change the colour temperature from 3 200 ˚K to 6 500 ˚K
by mounting colour temperature conversion filters on the
lens.
8 Adjust data with the ARROW key so that the vector
positions at shift by 10 % to the Cyan side of the
Vectorscope as shown in Fig. 4-1-11.
Fig. 4-1-11
8 Press the ENTER key for the next adjustment.
(11.2) White Balance 6500 ˚K ATW Limit B
Adjustment
Test Point: Video Output Connector
8 Aim the Camera at the White Chart or the White Paper.
8 Keep the colour temperature to 6 500 ˚K.
8 Adjust data with the ARROW key so that the vector
positions at shift by 10 % to the Cyan side of the
Vectorscope as shown in Fig. 4-1-11.
8 Repeat adjustment from (11.1) to (11.2) until the vector
positions at shift by 10 % to the Cyan side of the
Vectorscope.
8 Press the ENTER key for the next adjustment.
(12.1) 3200 ˚K R Gain Adjustment
Test Point: Video Output Connector
8 Aim the Camera at the Colour Chip Chart.
8 Set the gain control of the Vectorscope to the normal
position.
8 Return the colour temperature from 6 500 ˚K to 3 200 ˚K
by removing colour temperature conversion filters from the
lens.
8 Adjust data with the ARROW keys so that the Red gain
becomes 220 % ± 5 % (Burst Level = 100 %).
8 Press the ENTER key for the next adjustment.
(12.2) 3200 ˚K B Gain Adjustment
Test Point: Video Output Connector
8 Adjust data with the ARROW keys so that the Yellow gain
becomes 100 % ± 5 % (Burst Level = 100 %).
8 Press the ENTER key for the next adjustment.
(12.3) 3200 ˚K R Phase Adjustment
Test Point: Video Output Connector
8 Adjust data with the ARROW keys so that the Red Vector
phase becomes 108˚ ±2˚.
8 Press the ENTER key for the next adjustment.
(12.4) 3200 ˚K B Phase Adjustment
Test Point: Video Output Connector
8 Adjust data with the ARROW keys so that the Yellow
Vector phase becomes 160˚ ±8˚.
8 Repeat adjustment from (12.1) to (12.4) until both
Chrominance Phase and Gain are adjusted to proper
positions as shown in Fig. 4-1-12 and Table 4-1-1.
Fig. 4-1-12
Table 4-1-1
Shifts approx. 10%.
To Next Page
Loading...
