PANASTEREO SP23 - Page 32

PANASTEREO SP23 – Alignment with SMART MOD VI – DSP Matrix
32
21. TURN OFF THE LEFT AND RIGHT
SURROUND AMPLIFIER(S)
Switch off or disconnect the inputs to the left
surround and right surround amplifier(s).
22. IF A TWO CHANNEL REAR
SURROUND AMPLIFIER IS
INSTALLED GOTO 31
23. TURN ON THE REAR SURROUND
AMPLIFIER.
Switch on, or re-connect the input to the rear
surround amplifier.
24. COARSE SET REAR SURROUND SPL
LEVEL to 82dBC
Adjust the Rear Left Surround Output trimmer
(CSL) for approximately 82dBC SPL in the
auditorium.
25. EQUALISE REAR SURROUND
CHANNEL
Remove the Rear Equaliser from the SP23
and connect it via the extender card and cable.
Adjust the left equaliser controls for a
frequency response in accordance with the
standard ISO surround channel response
curve.
26. SET REAR SURROUND SPL LEVEL
TO 82dBC
Replace the Rear Equaliser card and adjust
the Rear Left Surround Output trimmer (CSL)
on the SP23 for 82dBC in the auditorium.
27. RE-CONNECT AUTOMATION CABLE
Re-connect the automation cable to the SP23.
28. TURN OFF PINK NOISE
Select the appropriate time delay setting on
the MOD VI Matrix board which will turn off the
pink noise source.
29. TURN ON THE LEFT AND RIGHT
SURROUND AMPLIFIER(S)
Switch on, or re-connect the inputs to the left
surround and right surround amplifier(s).
30. END OF PROCEDURE
The system is now ready to use.
31. ALIGNMENT OF TWO CHANNEL
REAR SURROUND AMPLIFIER
32. TURN ON THE REAR LEFT
AMPLIFIER
Switch on or re-connect the rear left surround
amplifier.